Can axel spindals be repaired if they have groves caused by a loss of bearings?

1. What does a damaged spindle look like?
2. Can you replace a spindle on an axle?
3. What causes spindle damage?
4. Can a spindle be repaired?
5. Can you weld a new spindle on trailer axle?
6. Can you replace spindle on torsion axle?
7. What causes cnc spindle bearing failure?
8. Do spindles wear out?
9. What is a spindle on truck?
10. Can you drive with a bad spindle?
11. Can a bad wheel hub cause vibration?
12. How much does it cost to replace a spindle on a car?

What does a damaged spindle look like?

Look for an scarring, gouges, discoloration, or scoring on the spindle. If the spindle is damaged then the bearings won't ride properly and can fail again or it can cause other problems such as uneven or excessive tire wear and ride quality problems.

Can you replace a spindle on an axle?

Far from a do-it-yourself job, trailer axle spindle replacement requires more than average results. Each new spindle addition must be installed securely and absolutely square with the trailer axle. If it is off by any amount, wheel tracking problems and premature tire wear are imminent.

What causes spindle damage?

Spindle damage can be caused by a variety of factors which can include but not limited to: high mileage, bearing failure, improper bearing installation.

Can a spindle be repaired?

As long as the spindle end is not split or metal is missing, the end can be welded up, machined down, and rethreaded. A spindle that has had excessive heat from a burned bearing will be damaged to the point that it needs replacing.

Can you weld a new spindle on trailer axle?

There are very few bolt-on spindles available; in fact, most spindles are welded to the axle tube. Replacing a spindle requires breaking the existing weld and then welding the new spindle in place.

Can you replace spindle on torsion axle?

If you have an Eliminator Torsion axle you can replace the spindle. ... If the torsion arm is exposed on the backside, you can place the castle nut back on the spindle so that it is even with the end of the spindle, and then hitting the rear of the spindle to force the spindle loose.

What causes cnc spindle bearing failure?

Spindle bearing contamination can occur when an operator directs an air hose at the spindle while blowing away coolant from the workpiece, fixtures other components. Mr. Hoenig says this can force particulate matter in the coolant into the spindle's bearings. (Misdirected coolant nozzles can also cause this.)

Do spindles wear out?

They do wear over time and will eventually need to be replaced.

What is a spindle on truck?

In an automobile, the wheel spindle, sometimes simply called the spindle, is a part of the suspension system that carries the hub for the wheel and attaches to the upper and lower control arms. Spindles are carried by steering knuckles or "uprights".

Can you drive with a bad spindle?

Driving with a bad wheel bearing can cause the axle/hub/spindle to weld itself from friction and heat causing the wheel to lock up and spin you out. More likely, the metal will wear away from the friction and the wheel/hub will become loose.

Can a bad wheel hub cause vibration?

Faulty wheel bearings can cause a vibration in your steering. It could also cause the vehicle to pull more toward one side. The steering feels “loose.” A broken wheel bearing will cause the steering to have a little more play which means it will feel looser.

How much does it cost to replace a spindle on a car?

How Much Does a Spindle Cost? Spindles can cost anywhere between $75 and $400. The price largely depends on whether you're going to get an individual spindle or a pair. The spindle's price also varies because of the complexity of the design, which will depend on the vehicle's make and model.