Did 95 Dodge Ram 1500 have a hydraulic controlled governor pressure on a automatic transmission?

1. What year did Dodge Ram 1500 have transmission problems?
2. How do you reset the TCM on a Dodge Ram 1500?
3. Are 5.2 and 5.9 transmission the same?
4. What is a 46RH transmission?
5. What year is the most reliable Ram 1500?
6. Which are 1500 series Ram trucks to avoid?
7. Where is the TCM located on a Dodge Ram 1500?
8. Where is the PCM located?
9. Does a transmission control module need to be programmed?
10. What is a TCM fuse?
11. Where is my transmission control module located?

What year did Dodge Ram 1500 have transmission problems?

Transmission Problems

Transmission problems are extremely common with 2012 RAMs and also dominate the list of the 2014 RAM 1500's most common issues. Problems in the transmission range from causing slight annoyance to making the truck dangerous to drive.

How do you reset the TCM on a Dodge Ram 1500?

If you are looking to "reset" the module just disconnect your battery for 30 minutes or so. Your TCM will be back to default and it will start 'learning' again from square one.

Are 5.2 and 5.9 transmission the same?

Any '96 or newer 5.2 or 5.9 transmission will work. The 5.9 flexplate has balance weight on it. The 5.2 is internally balanced and has no weight on the plate. You can use a 5.9 flexplate on a 5.2, just remove the weight.

What is a 46RH transmission?

The 46RH transmission is a 4 speed automatic that comes out of the A518 family. It replaced the A727 and was preceded by the 46RE transmission starting on all 1996 models. The biggest improvement over the 727 was that it featured in overdrive.

What year is the most reliable Ram 1500?

As far as fourth-generation trucks go, the 2017 Ram 1500 has proven to be the best year and least problematic of the last decade.

Which are 1500 series Ram trucks to avoid?

Here are the Dodge RAM 1500 years to avoid: 2003, 2010-2013 (5.7-liter V8), 2014, 2015, 2016.

Where is the TCM located on a Dodge Ram 1500?

The 2014 dodge ram 1500 tcm is located inside the rear of the transmission housing.

Where is the PCM located?

The PCM is most often located in the engine bay near the fuse box or inside the car near the fuse box. It can often also be located under the front windshield behind some covers. There are a few different locations that the manufacturer can place your vehicle's PCM, but the most common location is in the engine bay.

Does a transmission control module need to be programmed?

Does a transmission control module need to be programmed? ... When you install a new transmission control module in these vehicles, it must be programmed with dealer-level equipment. Your vehicle must also be towed to the dealership for the programming process to be completed.

What is a TCM fuse?

The TCM fuse is in the main fuse block and is probably 10 amps. If the fuse is blown, that is confirmation but the faulty fuse means there is a short circuit in the TCM and/or wiring that would have to be traced and repaired.

Where is my transmission control module located?

The transmission control module can often be found below the cover at the back of the transmission case. It should be just below the engine control module's position. Sometimes it's found under the center console in the interior or even under the hood near the battery or inner fender panel.