How do you reset SRS lightm on 2002 Honda Odyssey?

1. How do you reset the airbag light on a Honda Odyssey?
2. What does the SRS light mean on a 2002 Honda Odyssey?
3. How do you reset the SRS light?
4. Why is my SRS light on in my Honda Odyssey?
5. Can you reset airbag light without tool?
6. Will disconnecting the battery reset the airbag light?
7. What does SRS mean on a 2003 Honda Odyssey?
8. Why does my air bag light come on?
9. What is a SRS light?
10. What is SRS code for Honda?
11. How do you turn off the SRS light on a 2003 Honda Pilot?
12. How do you reset the airbag light on a 2005 Honda Odyssey?

How do you reset the airbag light on a Honda Odyssey?

Place the key into the ignition and turn it on, but don't allow the engine to turn over while still holding the wires together. Watch as the SRS light blinks on then turns off. Separate the wires right away and the SRS light will turn back on.

What does the SRS light mean on a 2002 Honda Odyssey?

The SRS light referes to the supplemental restraint system. This involves your airbags. The light indicates that the system has a problem and is disabled. We need to get the vehicle in to do some testing to isolate the problem and figure corrective measures.

How do you reset the SRS light?

Turn Your Ignition on and Off.

First, turn the ignition switch on. Next, wait for the airbag light to turn on – it normally stays lit for seven seconds before shutting itself off. Then, immediately turn off the ignition switch, and wait three seconds. Repeat the initial steps once or twice before starting the engine.

Why is my SRS light on in my Honda Odyssey?

The SRS (Supplemental Restraint System) Warning light on the Honda Odyssey is designed to only come on after the vehicle has been in an accident. If the light comes on otherwise, then there is a problem with the internal diagnostic system.

Can you reset airbag light without tool?

In some older cars, though, it is possible to reset the airbag light without a scanner by removing the car battery terminals. Check the wiring system underneath the driver or passenger seat for any loose wires or corrosion in the connector plug. Spray the connector plugs with an electronic cleaner and restart your car.

Will disconnecting the battery reset the airbag light?

Many air bag computers use non-volatile memory so even removing battery power won't erase them. It takes a scanner to erase them. But even if you do erase it, whatever turned the light on to begin with will turn it right back on so you accomplish nothing.

What does SRS mean on a 2003 Honda Odyssey?

2003 Honda Odyssey. Asked by Linda looo in Claremont, NH on September 10, 2015. Robert Lindsey on September 10, 2015. Hello! SRS stands for Supplemental Restraint System, as in the system that controls, importantly, controls the airbags in your vehicle.

Why does my air bag light come on?

The most common cause for the airbag light coming on is that the airbag system is deactivated or turned off. ... There may be an issue with a crash sensor, SRS module, or other airbag component. Alternatively, the sensor in the passenger seat that determines whether that airbag should be active or not may be faulty.

What is a SRS light?

The SRS warning light indicates a malfunction in the airbag system, front passenger occupant classification system or the seatbelt pretensioner system.

What is SRS code for Honda?

If your Honda airbag light remains on, it most likely means that the Supplemental Restraint System (SRS) has detected a problem with the airbag system. When your Honda airbag system functions properly, the airbag light comes on when you turn on the ignition but should turn off once you start the engine.

How do you turn off the SRS light on a 2003 Honda Pilot?

By the driver's left foot on the sidewall you will see an uncovered fusebox. There, you will find a yellow connector (very similar to your home computer internet wire). Its the only yellow connector there. 4-) the SRS Light will come on for 6 seconds, then go off.

How do you reset the airbag light on a 2005 Honda Odyssey?

To reset the airbag light sensor with this contact, change the ignition key to the "on" position (do not start the engine). The srs will glow for two seconds, then shut it off. Once the light is turned off, remove the shortening wire to shorten the circuit. The srs light will be turned on again.