What is the procedure for packing wheel bearings on a 93 s-10?

1. Can you over pack a wheel bearing with grease?
2. How much does it cost to have wheel bearings packed?
3. How often should you repack front wheel bearings?
4. Should I repack or replace wheel bearings?
5. Do you need to pack new wheel bearings?
6. What does it mean to pack the bearings?

Can you over pack a wheel bearing with grease?

Too much grease causes churning and higher temperatures. Semi-fluid grease must be used with a vented hub cap. It cannot be packed around the bearing as it will slump. Pump this grease into the wheel hub to the bearing cup (outer race) small inside diameter level at the “3 o'clock” and “9 o'clock” levels.

How much does it cost to have wheel bearings packed?

In a car, it will cost between $100 and $400 on average to have your bearings checked, repacked, or changed professionally (depending on your location and mechanic).

How often should you repack front wheel bearings?

To avoid a wheel bearing failure, you should regularly repack your wheel bearings. If you have a large RV and travel regularly, you should do this every year or 10,000 miles. If you're not taking your RV on extended trips and it's smaller, you should do it every year or 2,000 miles.

Should I repack or replace wheel bearings?

Expert Reply: We recommended to repack the wheel bearings on your trailer every 12 months or 12,000 miles. There is not a specific guideline as far as actually replacing the bearings. When repacking them with grease, you will also just want to check for any damage or wear and replace anything if needed.

Do you need to pack new wheel bearings?

Bearings are integral components that keep your wheels turning and prevent friction from wreaking havoc on your vehicle. But that grease eventually breaks down or dries up — and does so faster in dry or dirty conditions — so it's necessary to repack your bearings every so often. ...

What does it mean to pack the bearings?

The Definition

Repacking a bearing is the process of removing the parts of the wheel to access, clean, and add more grease to the bearing.